ECOGARD CELL FLAME RETARTANT READY FOR USE
- ECOGARD ® Cell flame retardant is a special flame retardant with extra dry grip for absorbent materials which mainly consist of cellulose such as wood, paper, card and cardboard.
- ECOGARD ® Cell is halogen-free and is therefore particularly environmentally friendly.
- Dependent on materials, the following fire classifications can be achieved: DIN 4102 B1, EN 13773 C1, ÖNORM Q1, Tr1, EN13501 all classes.
- Ecogard Cell
- bottle 1 kg
usage instructions and warnings for flame retardants!
1. General instructions for use Prior to treatment
please take note of manufacturing specifications, safety data sheets and warnings.
Only impregnate completely dry, clean materials. In general, you should cover all materials which could be affected by the spray mist. In particular, metals, plugs, electrical and electronic devices and also wood, stone, sensitive textiles and wall coverings can react to the spray. Flame retardant chemicals can cause damage such as rust or discolouration and do not constitute grounds for complaint.
2. Carry out testing prior to application!
According to current technological standards, there are textiles and floor surfaces, especially those consisting of synthetic fibres or mixtures which cannot be made sufficiently fire retardant. Therefore it is obligatory to carry out prior tests!
3. Health and work safety
ECOGARD® flame retardants are chemicals which are harmless for health and the environment. However, due to general work safety and health protection, please take note of the following points: Keep away from children; Keep away from food, drink and animal food; Don’t eat, drink or smoke whilst working; Do not inhale the spray; Wear a mask; Wear protection goggles; Avoid eye contact- in case of contact with eyes, rinse with copious amounts of water – seek medical advice in case of complaints; Seek medical advice in case of ingestion; After finishing work, wash hands, clothes and equipment thoroughly with water; Take note of risk of corrosion to iron and non-ferrous metals (cover these); Prior to disposal, clean container thoroughly with water. Please read the safety data sheet!
4. Skin tolerance
ECOGARD® flame retardants are generally well tolerated. Individual cases of allergic reactions are not excluded. Therefore, please avoid permanent skin contact with the product of the material treated with flame retardant. Therefore, treating upholstery is not recommended.
5. Please pay attention to official regulations!
Please pay attention to local official regulations. The purchaser is responsible for enquiring in good time with the competent authorities regarding required norms and documents. In many cases, official representatives require evidence of expert impregnation by a specialist company such as works certificates. Tüchler or ECOGARD® distribution partners provide these services.
Please take note that there are no general approvals for flame retardants. All certificates serve exclusively to document the principle suitability for a flame retardant for a specific material or material group.
Neither flame retardant nor works certificates may be used as a receipt or evidence of fulfilling norms for the flammability class of impregnated material.
Evidence of flammability classes according to norms are only available for a fee after fire testing the material impregnated with ECOGARD by an accredited testing institution. The purchaser carries the risk for attaining the necessary flammability class.
6. Lighter test
Due to reasons of personal safety, the lighter test may only be carried out by trained persons, over non-flammable surfaces, in well-ventilated rooms and exclusively on separated material samples of around 10 x 20 cm side length. Please note that the lighter test does not provide any conclusions regarding the fulfilment of norm related testing!
7. Warning after getting wet, washing or dry-cleaning
ECOGARD® flame retardants are water soluble. If the impregnated material gets wet or is washed, ECOGARD ® will dissolve and must be treated again. The flame retardant effect must be checked again after dry cleaning.
8. Limitations of the effectiveness of flame retardant impregnation
Flame retardants protect against accidents and small fires caused by carelessness. In the case of large fires, arson, use of fire accelerants such as petrol, materials impregnated with flame retardants fail and will add to the fire load..
9. Side effects and liability disclaimer
ECOGARD® products were designed for use on commonly used materials. Dependent on the material, undesired side effects such as: limitation of fastness, such as light fastness/ reduced resistance to rubbing, changes to colour, reduction in strength (tearing/breaking), appearance of corrosion, changes in handling, changes in measurements, changes in soiling behaviour, contour formation due to water drops can occur. Allergic reactions, such as skin irritation, dripping of flame retardant in the case of synthetic fibres, especially acrylic materials, may occur. Refunds and compensation claims based on the aforementioned or similar effects are excluded, regardless of the time period between the occurrence of the undesired side effect and impregnation.
10. Impregnating materials by TÜCHLER
Purchaser warranty claims in accordance with the terms and conditions only apply in the case of written approval provided by TÜCHLER of the objects (materials) to be impregnated and of other objects (materials) in close proximity. In all other cases, the risk of changes to colour, measurements or any other changes, as well as the fulfilment of respective norms for the material impregnated by the seller as well as of other objects (materials) in close proximity are the responsibility of the purchaser.
The abovementioned items, in particular items 5 and 9, apply in full. After impregnation, TÜCHLER issues a works certificate regarding the impregnation work. Please note that this certificate is not deemed as evidence for the fulfilment of norms for flammability classes for the impregnated materials. The recognition of this certificate is at the discretion of the official authorities. Evidence of flammability classes according to norms are only available for a fee after fire testing the material impregnated with ECOGARD by an accredited testing institution. The purchaser carries the risk for attaining the necessary flammability class, as well as the cost for any further impregnation and follow-up testing.
Our service team will be happy to advise you and help you with your request!