Curtain rail with manual cable pull for very large curtains, backdrops, dividing curtains, blackout curtains in film and television studios, multi-purpose halls, stages, theatres, etc.

Even very high and wide curtains can be opened and closed with the direct pulling of the pull rope. The large load-bearing capacity of the TT1 rail profile reduces the necessary suspensions to a minimum, thus saving assembly time and costs.

Technical data and the load table can be found at the bottom of this page after the products.

For the assembly drawings, click on the desired configuration:

Configuration with overlap

When using this configuration, towing cars with overlappers are used. The encroacher carries the curtain about 20cm in front of the train car. In the case of curtains that only move to one side, the pulley of the rope can be covered. This is important for curtains that are supposed to close against a wall, otherwise a gap will remain between the curtain and the wall.
If a curtain with a central opening is moved, an overlap of the curtain parts is achieved even if the rail profile is inserted without overlapping.

TT2-SCHNURZUG MIT ÜBERGREIFER AÜßENLÄUFIG MIT SEIL 1
TT2-SCHNURZUG MIT ÜBERGREIFER AÜßENLÄUFIG MIT SEIL 3

Configuration with overlapping of rail profiles

The advantage of overlapping with rail profiles lies in the unrestricted overlap path. As a result, large main curtains on stages or very high blackout curtains in particular close safely. However, this configuration is only possible when using the curtain pull to move a center-opening curtain. If you want your curtain to open only to one side and cover the pulleys of the rope at the end of the rail, please use the "Configurations with overlapper".

TT2 SCHNURZUG MIT ÜBERLPPUNG MIT SEIL 1
TT2 SCHNURZUG MIT ÜBERLPPUNG MIT SEIL 3

AÜ 180723